Details that need to be paid attention to in the use of sandblasting machine
1. The amount of sand blasting of the sandblasting machine is small, and even no sand is produced: the sand material in the sand storage tank is used up, turn off the gas, and slowly add the corresponding sand material.
2. The sandblasting gun of the sandblasting machine may be blocked: after the gas is stopped, go to the nozzle to see if there is any foreign matter, and if there is any foreign matter, just clean it up; the other is to see if the sand material is dry, and the sand material is too wet It can also cause blockage, so the compressed air must be dry.
3. The sandblasting pipe is blocked: the pipe is blocked by dirt. After the gas is stopped and turned off, the nozzle is removed first, then the sandblasting machine is turned on, and the foreign matter is blown out with the high-pressure gas of the air compressor; Remove the tube to clean or replace it with a new one.
4. Sandblasting abrasives are wet and combined to cause no sand: This is to clean the nozzle of the spray gun, pour out the sandblasting abrasives, and filter them with a screen after drying.
5. A large amount of water generated by the compressed air of the air compressor matched with the sandblasting machine will not only cause the sand material to be wet, but also cause the sand blasting pipe wall to be wet and adhere to the sand material, which will slowly block the pipeline, so this should be avoided. That kind of thing happens, comes with a dryer.